Creates a linear slot by defining the slot’s orientation, length, and width. The first two clicks specify the arc centers, and the third click specifies slot width. Creates a linear slot by defining the placement and distance of slot arc centers, and then the slot width. Click Sketch tab Create panel and choose one of the following:.To quit, press Esc or click another command.Move the cursor and click to set the second and third points, depending on the type of rectangle you’re drawing.Click in the graphics window to set the first point.The first click sets the center, the second click sets the direction and distance of one side, and the third click sets the distance of the adjacent side. Creates a rectangle by defining the center, direction, and the adjacent side. The first click sets the center point the second click sets a corner. Creates a rectangle by defining the center, width, and length of the shape. A three-point rectangle can have any alignment.
The first click sets a corner, the second click sets the direction and distance of one side, and the third click sets the distance of the adjacent side. Creates a rectangle by defining the length, direction, and the adjacent side. Two-point rectangles are aligned with the sketch coordinate system. Creates a rectangle using two clicks that define diagonal corner points. Click Sketch tab Create paneland choose one of the following:.The rectangle tools create rectangles from a corner or center point in two or three clicks.